static bed 是什么意思

static bed的中文意思是: 静态床

static bed例句大全

  1. Composite multitube electric static precipitator for circulating fluidized bed boiler

    循环流化床锅炉配套复合式静电多管除尘器

  2. Large static charges may build up in the bed causing spark discharges.

    大量静电荷可能在床内积聚而引起火花放电。

  3. Electrosynthesis of glyoxylic acid in a static bed reactor with cooled cathode

    阴极冷却固定床反应器电合成乙醛酸

  4. The jet velocity in the center of spouting zone is less for a spouted bed with high static bed height

    此时,对比低静止床层高度的床体,高静止床层高度的床体在中心喷射区域的气体射流速率更小,中心喷射区两边的密相区域内的气体流动速率更大。

  5. CO, H2, CH4 and short chain hydrocarbons increased with static bed height increasing.

    静止床高增加时,有利于CO、H2、CH4以及低碳氢化合物的生成。

  6. Static State Simulation of Operating Parameters of Fluidized Bed Dryer for white Sugar

    白砂糖流化床干燥器操作参数的静态仿真

  7. Due to fluidization, the static bed of sand particle s expands and the height of the expanded bed depends

    由于硫化作用,静态床沙粒的膨胀和膨胀床的高度主要取决于硫化速度。

  8. The higher static bed height, the bigger resistance of bed materials to flow, result in more spouting

    静止床层高度大的床体,床料对喷动气流的反作用力也越大,导致喷动气流向密相区扩散的量越多。

  9. Also, the difference in pressure between any two points in a bed is roughly approximated by the static

    还有,床层中任意两点间的压差大致等于这两点间床层静压头。

  10. The relationship between the drying rate and drying air temperature, superficial air velocity, static

    提出了干燥速率与干燥介质温度、气流表观速度、床层静止高度、气流脉动频率以及气流分布板开孔率之间的关系,同时也得出了床层压降与床层静止高度的关系。

  11. experimental parameter, Researched the influence of particle diameter, particle size distribution , static

    研究了大颗粒流化床中物料的粒度组成、静床层高度和床层表观风速对床层膨胀比的影响,研究了床层中的压力分布以及压力脉动的变化。

  12. The process of the two-phase flow in guns may be derided into two stages, that is, the static bed stage

    火炮膛内两相流动过程可划分为两个阶段,即固定床阶段和流化床阶段。

  13. Static bed height and operating bed height drop suddenly as the temperature increases .

    随着温度的升高,总碳转化率和二甲醚的选择性均略有降低,甲醇产量基本不变,而二甲醚的产量有所减小,静液床层高度和操作床层高度均降低。

  14. But both operating bed height and static bed height are increased obviously because average gas holdup

    随着反应器直径的减小,床层平均气含率及表观气速均较大幅度的增加,静液床层高度和操作床层高度均增加。

  15. The influence of pressure, static bed height and fluidized air on the minimum spouting velocity was studied

    研究了压力、静止床高及流化风对最小喷动速度的影响。

  16. the main frequency increases with increasing pouting gas velocity, while it decreases with increasing static

    结果表明:床层不同位置压力波动的主频随喷动气流速的增大而增大,随静止床高的增大而减小;

  17. Fluctuation Complexity varied with different particle , static bed height diameter particle and axis position

    同时本文还对不同静床高、轴向位置、平均粒径的体系的涨落复杂性进行了研究。

  18. Through the evaluation results requirements, we set the static and dynamic optimization index to retrospectively

    通过评估结果的要求,设定动、静态优化指标对床身进行回溯设计。

  19. Effects of parameters, such as bed temperature when coal is fed, coal feeding rate, in bed heat transfer

    研究了加煤床温、加煤速率、埋管受热面、静止床高、热烟气温度和流量等参数对启动过程的影响规律以及床层温升速率的变化。

  20. Composting was done in an aerobic static bed of composting based temperature feedback and control via

    采用温度反馈通气量控制的好氧静态堆肥技术,在堆体温度40℃左右时停止通风。

  21. The influences of the air velocity, pulsating intensity and static bed height to the heat transfer coefficient

    研究了风速、脉动强度和静止床层高度对水冷夹套的换热系数的影响;

  22. In this paper, using the finite element method, we completed the computation of static rigidity for a

    本文介绍采用有限元法计算车床床身的静刚度。

  23. Bed frame: Uses the high quality section welding formation, the superficial static electricity spurts

    床架:采用优质型钢焊接成型,表面静电喷塑,牢固耐用,美观大方。

  24. We using CAD software established lathe bed of parameterized modeling, and learn the dynamic and static

    借助CAD软件建立了床身的参数化建模,并针对其三维模型进行了有限元分析,了解了其动静态特性并给予评估。

  25. The influences of fluidizing number, injection velocity, partical diameter and the static bed height

    研究了流化数、射流速度、颗粒平均粒径和静态床层高度对射流深度的影响。

  26. The Design and Research for Principal Axis Low Speed Control System of moving and Static Test-bed about

    直升机旋翼动平衡试验台主轴低速控制系统的设计与研究

  27. Considering the fluidization quality of the system, proper selection of static powder bed height and

    在权衡流化质量的基础上,粉体静止料层高度和出粉口相对高度的选取至为关键。

  28. Similar to the two dimensional fluid bed, we also experimenting the influence of particle diameter, particle

    研究了物料粒度组成、静床层高度和表观风速对床层压力分布的影响,分析了床层压力脉动的变化情况。

  29. Bed with single bed, double bed, king bed.

    床有单人床、双人床、特大床等。

  30. fluctuation is weakened with increase of injection velocity, fluidization number, particle mean diameter and static

    结果表明:垂直向上射流的脉动随射流初始速度、流化数、静态床层高度以及颗粒平均粒径的增加而减弱。

  31. analysis of pressure fluctuation signals in different experimental conditions, we draw the conclusion that static

    经过对不同试验工况下的数据进行分析,可以看出表观气速和静床高对流化床流化状态的影响。

  32. The test-bed has been designed with view to determine static capability and absorption of energy capability

    本文研究了一种专门用来检测汽车座椅头枕静态性能和能量吸收性的试验台。

  33. The first stage was aerobic static bed of composting based on temperature feedback and control via aeration

    采用自制的静态好氧床进行一次发酵,过程控制采用温度反馈通气量控制方法,发酵周期20d;

  34. spouted pressure drop was inversely proportional to the particle s diameters and proportional to the static

    最大喷动压降与颗粒粒径成反比,与静床层高度和表观气速成正比;

  35. The Aero-tyre test-bed is an important equipment for the test of static capabilities of Aero-tyre.

    飞机机轮径侧向联合载荷试验系统是检验飞机机轮静态性能的重要试验设备,介绍了飞机机轮径侧向联合载荷试验台及基于可编程控制器(PLC)集成的控制系统的研制。

  36. In case of an increase in the fluidized gas velocity, static bed layer height and particle diameter there

    当流化气体速度、静态床层高度和颗粒粒径增加时,颗粒的内循环增强;

  37. of analyzing the cause of the generation of particle internal circulation in a gas solid fluidized bed

    分析了气固流化床内颗粒内循环产生的原因,进而,分析了流化气体速度、静态床层高度、颗粒粒径以及压力对颗粒内循环的影响。

  38. The product group"bed mattresses"comprise bed mattresses, the materials filling the bed mattresses, wooden

    床垫产品包括弹簧床垫,充填床垫的乳胶、聚氨酯泡沫塑料及弹簧等物料,木制床架等。

  39. After the primary air is shut down suddenly, the static bed height declines significantly in the direction

    采用定向风帽时,沿着风的流向,床静态后床面高度有明显的倾斜。

  40. The Static Problem in Electro - Static driven comb Micro resonant Structure

    静电梳微谐振子结构中的静力学问题